A PHP Error was encountered

Severity: Notice

Message: Undefined index: /support/knowledge_base/

Filename: controllers/knowledge_base.php

Line Number: 89

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 94

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 95

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 96

A PHP Error was encountered

Severity: Warning

Message: curl_setopt(): CURLOPT_FOLLOWLOCATION cannot be activated when safe_mode is enabled or an open_basedir is set

Filename: models/zd_model.php

Line Number: 38

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 108

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 109

欢迎访问Roland ProAV中文网站 - 支持 - - UVC-02: The other party in the conference isn’t hearing the audio input from the HDMI IN connector or the AUX IN jack.
AS

UVC-02: The other party in the conference isn’t hearing the audio input from the HDMI IN connector or the AUX IN jack.

If the sound that’s input to the HDMI IN connector or the AUX IN jack on the UVC-02 is not heard by the other party in the conference, this might be because the noise suppression function on your software is turned on. Check the software’s noise suppression settings.

Also, check the various settings.

  1. Use the [HDMI] knob and [AUX] knob on the UVC-02 to adjust the input level.

  2. Connect your computer on which the UVC-02 Setup Tool is installed to the UVC-02 by using the included USB cable.
    - The UVC-02 Setup Tool launches automatically.
    uvc-02_connect_pc.png

  3. Click the [AUDIO] tab to open the AUDIO ROUTING SETTINGS, and set the output switch of signal going “To USB OUT” for the relevant input (HDMI or AUX) to the ON position.
    UVC-02_hdmi_aux_out_sw.png

支持

Quick Links