On the V-1SDI, you can change the following on the Multiview output:

• Turn on/off Text Labels
• Turn on/off Tally Borders
  • Red and Green boxes around A and B bus sources
• Turn on/off/position Audio Level Meter
  
  
  •  Note: On the V-1HD, you can only position the audio meters.

 

Configuring the Multiview

 

• On the V-1SDI panel, press and hold [ SETUP ] for 2 seconds to open the SETUP Menu.
  
  
  • Note: This displays the SETUP menu on the monitor connected to the MULTI-VIEW output connector.
    
    

 

 

•  Using the [ AUTO ] button, navigate to Page 15/16, SYSTEM.
  
  
  • Note: You can use the [ MIX ] and [ CUT ] buttons to quickly navigate menu pages. 
    
    

• Set the 1st through 3rd options: PVW INDICATOR: LABEL, TALLY, and AUDIO LEVEL METER.
  
  
• Using the Fader Bar, change the setting to customize the Multiview to your preferences.
  
  
• In addition to turning the AUDIO LEVEL METER on/off, you can also position it along the UPPER or LOWER areas of the Multiview.

 

 

More Information

 

For more information about the Multiview Output, refer to the V-1SDI Reference Manual.

Note: This is a separate document from the Owner's Manual and RCS Owner's Manual.