Before connecting your V-1200HD to a PC you have to make sure that it meets the following specifications:

Compatible Operating Systems: Microsoft Windows 7 Service Pack 2
Processor: Intel Core 2 Duo or higher, or compatible processor
* The compatibility of compatible processors is not assured.
Memory (RAM): 2 GB or more of RAM/ 64 MB or more of VRAM
Required Disk Space: 200 MB or more
Display Resolution/Colors:
1,920 x 1,280 resolution or higher, Full Color (24-bit) or higher
On computers running Windows, the Aero interface must be enabled.
Other Matters: Connecting to the V-1200HD requires a LAN connection.

* Operation of V-1200HD RCS on a standard computer that satisfies the conditions just described has been confirmed, but all operation under these conditions is not
assured. Please be aware that even under identical conditions, computer-specific differences in design specifications or usage environment might result in differences
in processing capacity.

Here are the steps to connect the RCS with your V-1200HD:

• Type "Control Panel" into the search bar and hit <ENTER>
• Under Network and Internet click “View network status and tasks”
• Click "Change Adapter Settings"
• Right Click any of the available networks
• Use the pop up menu to choose "Properties"
• Select “Internet Protocol Version 4 (TCP/IPv4)” and click Properties.
• Select “Use the following IP address” then enter the values:
1. Check/Select "Use the following IP address"
2. Use IP address: 192.168.10.1
3. The Subnet mask will allocate 255.255.255.0
4. Leave Default Gateway Blank
5. Check/Select "Use the following DNS server addresses"
6. Leave "Preferred DNS server" and "Alternate DNS server" blank
7. Click OK to save settings
   
   
• To connect a second computer you must use a Ethernet switching hub
• Follow steps 1-7 but set the IP address for the second PC as 192.168.10.2

**NOTE**
- Use a Category 5e or higher shielded Ethernet cable for connection. Crossover cables and straight cables are both supported.

- Connect no devices other than the V-1200HD, V-1200HDR units, and computers installed with V-1200HD RCS to the same network.

- Communication is not established if the V-1200HD and the V-1200HDR are connected after the power has been turned on. If the connection
has been made while in this state, communication can be established by resetting the power on just the V-1200HDR.