A PHP Error was encountered

Severity: Notice

Message: Undefined index: /support/knowledge_base/

Filename: controllers/knowledge_base.php

Line Number: 89

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 94

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 95

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 96

A PHP Error was encountered

Severity: Warning

Message: curl_setopt(): CURLOPT_FOLLOWLOCATION cannot be activated when safe_mode is enabled or an open_basedir is set

Filename: models/zd_model.php

Line Number: 38

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 108

A PHP Error was encountered

Severity: Notice

Message: Trying to get property of non-object

Filename: controllers/knowledge_base.php

Line Number: 109

欢迎访问Roland ProAV中文网站 - 支持 - - When using 2 1608 and 2 0816 units for a 32in 16out config, is it possible to control both 0816 FOH units with a single s-4000r remote? Can this be done with a serial rs232 switch or hub connecting the 2 0816 units? Or is this described configuration only
AS

When using 2 1608 and 2 0816 units for a 32in 16out config, is it possible to control both 0816 FOH units with a single s-4000r remote? Can this be done with a serial rs232 switch or hub connecting the 2 0816 units? Or is this described configuration only

Hello; Because each of your S-1608 snake systems must operate on independent REAC networks, you will need to either use two S-4000R Remote Controls or a PC with two RS-232 ports. For ease of control, we recommend using a PC with two RS-232 ports running the S-4000RCS program. You can use two USB-RS232 adapters, a PCI RS-232 card (for desktop) or a PCMCIA card with two RS-232 ports (recommended if your laptop supports PCMCIA). This will give you at-a-glance monitoring and control of all your pre-amps and an easy way to recall presets.

支持

Quick Links