The Autoscan feature can be used to switch between channels/ source automatically. This is a good application for Digital Signage. Here's how you can enable it and different settings:

1. Press and hold SETUP until it displays the MENU on the Preview screen.
2. Using the MIX and CUT you can navigate the menu pages faster.
3. Navigate to page 15 of 16.
4. Use the ^ Arrow (DSK) and v Arrow (AUTO) to select AUTO SCAN.
5. Use the T-Bar to set the either:
   OFF = Disabled
   ON = Enabled

Once enabled you can set up the following parameters:

• SCAN TIME: 0 - 120 seconds : This sets a time interval for how long a channel/ Source is displayed
• TRANS TIME: 0 - 4 seconds :  This sets a time length for how long a transition takes

With this unique feature you can cycle through your sources to display your message however you want.