If you would like more information on this topic, please contact support via Roland Backstage.

 

 

This is a guide on how to set the video on channels 1 through 4 to switch automatically in sequence.

Follow these steps:

1. Press and hold the [(TAP) BPM] button (for 2 seconds or longer) to display the SETUP menu.

2. Use the [^] and [v] buttons to navigate to Page 3



3. Select “AUTO SCAN.”

4. Use the A/B fader to set this to "ON"

"ON" : Video automatic switching is turned on. The video on channels 1 through 4 is switched automatically.
"OFF": The video automatic switching feature is turned off.

5. Press the [(TAP) BPM] button to quit the menu.

Under the same Setup Menu Page 3 you can set the transition interval between video input and the time applies to the video transition.

AUTO SCAN TIME: Sets the display interval for video within a range of 1 to 120 seconds.
AUTO SCAN TRANS TIME: Sets the time the video transition takes, within a range of 0.0 to 4.0 seconds.
                                       * These are effective when a mix or wipe is selected as the transition effect.

* If the time the video transition takes is longer than the video display interval, the next transition starts before the current transition is complete.

• Any channels carrying no video input are skipped.
• Switching the video manually is not possible while an automatic switch is in progress.